Built on Trust, Powered by Expertise
AIRPRO Enterprises Inc. supplies electrical, mechanical, instrumentation and automation products — and backs them with the engineers who build the panels, program the controls and maintain the compressed air and nitrogen systems they run in.
Most plants buy components from one company and call another when something stops. We do both, so the people quoting your parts are the people who know your machines.
PLC, HMI and SCADA programming, motor controls, machine guarding and safety, and machine upgrades.
Automation services →Preventive maintenance, repair, controls upgrades and sequencing — plus dryers, purification and on-site nitrogen generation.
Air system services →Control panel assembly, electrical and mechanical installation, and old controllers rehabilitated to current hardware.
Panel & project works →Valve replacement and tie-ins on live lines — no full shutdown, no draining the system down to do it.
Live-line services →Ordered through official channels, warranted by the manufacturer, and supported by our own engineers on site.
Compressors and air treatment for plants that cannot afford unstable pressure, together with the Gardner Denver blower and vacuum lines.
The moving parts of a production line — specified from the duty cycle up, not picked from a catalogue page.
Make the gas where you use it. PSA generators sized to your purity, flow and pressure — fed by the compressed air system we already look after.
We also supply and service equipment from other established electrical, automation, valve and air-movement manufacturers — ask us about a specific brand.
AIRPRO was founded in 2024 by engineers with more than 30 years of combined experience in electrical controls, automation, and compressed air and gas generation and systems. We kept meeting the same problem on site: parts that were hard to verify, and suppliers who could quote but not commission.
The same four steps whether you need a single solenoid valve or a compressor room brought back under control.
We take the nameplate data, the readings and the constraints — on site where it matters, over email where it doesn't.
An engineer confirms the part or scope, offers a genuine equivalent where lead time demands it, and prices it clearly.
Delivery, installation, programming and start-up — tested against the way the machine actually has to run.
Preventive maintenance on schedule, reports after every visit, and critical spares planned before they are urgent.
Control panels rehabilitated, nitrogen generation installed, valves replaced on live lines — our own projects, not stock photography.
Locators in the country's major economic zones — semiconductor and electronics, power generation, food and beverage, industrial gases and heavy manufacturing.
Client names and marks go here after written consent from each account. Until then the site describes the sectors served instead.
Send the nameplate photo, the part number or the scope. An engineer — not a call centre — comes back to you.